Installation Instructions

a
)
Check your rough opening dimensions.
The rough opening height should equal
the door height plus 2-½". The rough
opening width should equal the door
width plus 2".
b
)
Check the opening for plumb and
square. Check both walls for plumb
(
fig.1
)
and all four corners for square
in the rough opening
(
fig.2
)
. Make
the necessary corrections prior to install-
ing the door unit. If the opening is not
plumb the door will not hang correctly.
INTERIOR SINGLE DOOR
INSTALLATION INSTRUCTIONS
REQUIRED TOOLS
Safety Glasses • Gloves • 48"-72" Level • Hammer • Tape Measure • 24" Square • Screw Gun
2-½" Wood Screws Qty: 3 • Wood Shims
(1pkg.) • Pliers • Chisel • Utility Knife • Carpenter's Pencil • Hanger Hardware Bag
WARNING
Door Units Are Heavy! Use an adequate number of people to set the unit and prevent injuries or damage to the door.
1
)
Checking and Prepping the Rough Opening
2
)
Door Unit Prep
3
)
Install Hinge Side Hanger
4
)
Install Strike Side Hangers
5
)
Install Opposite Side Hangers
6
)
Bend Hangers
7
)
Draw Plumb Line
g. 2
g. 5
g. 6
g. 7
g. 8
g. 9
g. 10
g. 11
g. 1
g. 3 g. 4
a
)
Remove the packaging materials from the door. This
includes and banding, boxes, sleeves, and bracing boards
(
fig.3
)
. Leave the yellow door plug installed in the
door at this time
(
fig.4
)
.
a
)
Install one Quick
Plumb door hanger
flush with the top of
each hinge. Use three
of the supplied ½"
screws per door
hanger.
(
fig.5
)
.
a
)
Install three more
Quick Plumb door
hangers on the strike
side of the jamb
directly across from
the locations of the
hinge side hangers.
(
fig.6
)
.
a
)
Flip the door over
and install three more
door hangers to each
jamb directly in line
with the first six
hangers
(
fig.7
)
.
a
)
Using a pliers,
bend the six clips
on the non-hinge
side (applied in
step 5) so that
they are parallel
with the jambs
(
fig.8 & 9
)
.
a
)
Draw a plumb
line approximately
½" in from the
rough opening
on the hinge
side of the door
(
fig.10 & 11
)
.