Installation Instructions

a
)
Check your rough opening dimen-
sions. The rough opening height should
equal the door slab height plus 2 ½”.
The rough opening width should equal
the door slab width plus 2” for a door
without an astragal; and plus 2 ½” for a
door with an astragal
(
fig.1
)
.
b
)
Check the opening for plumb and
square. Check both walls for plumb
(
fig.2
)
and all four corners for square
in the rough opening
(
fig.3
)
. Make the necessary corrections prior to installing the door
unit. If the opening is not plumb the door will not hang correctly.
Install one quick plumb door hanger flush with the top
of each hinge. Use the supplied screws included with the
door hanger
(
fig.4
)
. This should be repeated for all six
hinges.
PREHUNG INTERIOR DOUBLE DOOR
INSTALLATION INSTRUCTIONS
REQUIRED TOOLS
Safety Glasses • Gloves • 48"-72" Level • Hammer • Tape Measure • 24" Square • Screw Gun/Drill • Wood Chisel • Utility Knife
Punch • Marker • Exterior Caulk
(Paintable Silicone Recommended) • 2-½" Wood Screws Qty: 6 • Wood Shims (1pkg.) • Door Hangers
WARNING
Door Units Are Heavy! Use an adequate number of people to set the unit and prevent injuries or damage to the door.
1
)
Check Rough Opening
2
)
Install Hanger
3
)
Opposite Hangers 4
)
Bend Hangers
g. 1
g. 3
g. 2
g. 4
Place six additional hangers directly in
line with the hinge side hangers that
were just installed in step 2
(
fig.5
)
.
Using a pliers, bend the six clips on the non-hinge side
(applied in step 3) so that they are parallel with the
jambs
(
fig.6
)
.
g. 5 g. 6
IntDoubleDoorInstall.indd 1 7/23/15 11:53 AM