Installation Instructions

SPLIT JAMB INTERIOR DOOR
3
)
Setting the Door Unit
g. 8
g. 11
g. 7
g. 10
g. 13
g. 6
g. 9
g. 12
a
) Set the door unit, centered into the rough opening
(
g.6
).
Use one 4d nishing nail at the
top of the casing to hold the unit into place about 12” from the top of the casing on the hinge
side.
(
g.7
)
.
b
) Use a utility knife to remove the door clip and carefully open the door
(
g.8
)
.
c
) Shim behind each of the three hinge locations
(
g.9
)
until the jamb is both plumb and
square on the hinge
side
(
g.10
)
.
d
) Once the unit is plumb and square, drive one 6d nishing nail through the frame and
hinge shim and into the stud wall for each shim location
(
g.11
).
Note: Do not nail through
the stop.
e
) Close the door unit and shim the strike side in three locations directly opposite
of the hinge side shims until the door reveal is even from top to bottom of the door
unit
(
g.12
)
.
f
) Open the door and place one 6d nishing nail through the jamb and shim and
into the stud wall for each shim location
(
g.13
)
. Note: Do not nail through
the stop.