Installation Instructions

INTERIOR DOOR SYSTEM
a
)
All Mastercraft doors are set up with a 2-1/8"
bore hole set at either a 2-3/8" or a 2-3/4"
backset (depending on door type). All crossbores are
set for a 1" drivepoint latch. This is done to allow
installers to utilize drive point latch systems, radius
plate sytems, or square plate systems
(
fig.26
)
.
b
)
To install the backset as a drivepoint system,
simply follow the lock manufacturers instruction for
converting to a drivepoint. Hammer the drivepoint
into place making sure the angled portion of the
backset faces the jamb
(
fig.27
)
.
c
)
Using the manufacturers instructions, install the
lockset
(
fig.28
)
.
d
)
Install the strike plate on the jamb. Our jambs
are mortised for a ¼" radius strike plate. If the
lock manufacturer has supplied a square plate,
mark the outside edge
(
fig.29
)
and use a chisel
to remove the excess wood material from around
the corners of the plate
(
fig.30
)
.
14
)
Installing the Lockset
15
)
Apply Casing
g. 28
g. 31
g. 27
g. 29 g. 30
a
)
Apply casing to the unit as
desired.
(
fig.31
)
.
Our wallcovering department carries all the quality products you need to finish
your new door. Choose from a complete line of sandpaper, stains and finishing
products to give your project that professional look. Remember, always follow all
the manufacturer's finishing instructions.
1.) Surface must be clean and dry. 2.) Lightly sand and clean door on all sides.
3.) Apply first coat of finish. 4.) When first coat is dry, lightly sand and then clean
surface. 5.) Apply at least one finish coat. Allow ample drying time between coats.
IMPORTANT: Apply a minimum of two coats of paint, varnish, or sealer to all six
sides of the door.
16
)
Finishing Recommendations
g. 26
Questions or Concerns: For guest assistance contact
MASTERCRAFT
®
by sending an email to:
[e-mail]
For more information, including troubleshooting help
and videos, please visit:
www.MidwestManufacturing.com