User Manual

20V max* LITHIUM-ION CORDLESS DRILL/DRIVER - 054-1332-620V max* LITHIUM-ION CORDLESS DRILL/DRIVER - 054-1332-6
15 16
Trigger switch (fig 3)
To turn the drill/driver ON, depress the trigger
switch. To turn it OFF, release the trigger switch.
Variable speed (fig 3)
The variable-speed trigger switch delivers higher
speed with increased trigger pressure and lower
speed with decreased trigger pressure.
Direction-of-rotation selector
(forward/centre-lock reverse)
(fig 4)
The direction of rotation of the bit is reversible and
is controlled with the direction-of-rotation selector
located above the trigger switch. With the drill/driver
held in normal operating position:
Position the direction-of-rotation selector to the
left of the tool for forward rotation.
Position the direction-of-rotation selector to the
right of the tool for reverse rotation.
Position the direction-of-rotation selector in the
centre to lock the tool off.
NOTE:To prevent gear damage, always allow
the drill/driver to come to a complete stop before
changing the direction of rotation.
NOTE: The drill/driver will not run unless the
direction-of-rotation selector is engaged fully to
the left or right.
OPERATING INSTRUCTIONS
To attach battery pack (fig 2)
CAUTION!
Avoid the possibility of accidental
starting. Always take care not to
activate the trigger switch when you are
attaching the battery pack or performing
other adjustments to the tool.
NOTE:When placing a battery pack on the tool,
be sure that the raised rib on the battery pack
aligns with the groove on the cordless drill/driver
and the latches snap into place properly. Improper assembly of the battery pack can cause damage to
internal components.
1. Lock the trigger switch on the drill/driver by placing the direction-of-rotation
(forward/centre-lock/reverse) selector in the centre position.
2. Align the raised portion on the battery pack with the groove on the bottom of the drill/driver, and then
attach the battery pack to the drill/driver as shown.
3. Make sure that the latch on the battery pack snaps into place and that the battery pack is secured to
the drill/driver before beginning operation.
To detach battery pack (fig 2)
CAUTION!
Avoid the possibility of accidental starting. Always take care not to activate the trigger switch
when you are detaching the battery pack or performing other adjustments to the tool.
1. Lock the trigger switch on the drill/driver by placing the direction-of-rotation selector
(forward/centre-lock/reverse) in the centre position.
2. Depress the battery-release button located on the front of the battery pack to release the battery pack.
3. Pull forward on the battery pack to remove it from the drill/driver.
OPERATING INSTRUCTIONS
fig 4
Forward Reverse
fig 3
Direction-of-
Rotation Selector
Variable
Speed
Trigger
Switch
fig 2