Technical Specifications

CONCRETE BLOCK
by
Type S Mortar Mix
Menards Sku# 189-1180
Type S Mortar is designed for laying:
• Brick
• Concrete Masonry units
• Stone
• Walls
• Columns
• Brick/Stone Veneers
• Tuck Pointing
Product Description
Surfaces to receive Mortar Mix should be clean and free
of dirt, loose debris, grease, oil, etc. for the best possible
bind.
Type S Mortar Mix is a contractor grade mortar mix
designed for laying brick, concrete masonry units, and
stone. It requires only the addition of water and can be
used for structural and non-structural applications above
or below grade. Meets or exeeds ASTM c-270.
Product Use
Installation
Weight-Unit: 80 lb (36.3kg)
Pallet Quantity: 49/Pallet
Bagging Specications
Pre-Blended Contractor Preferred
• Moist curing of masonry mortars is required if
conditions are hot, dry, or windy. In such cases, a
gentle mist of water applied to the surface will prevent
premature drying and improve the strength of the
mortar. Protect mortar from freezing during the rst 48
hours. Plastic sheeting and insulation blankets should
be used if temperatures are expected to fall below 32
degrees F (0 degrees C).
Curing Information
• Apply a full bead of mortar onto the base, approximately
1/2"- 3/4" (12.7 - 19.1 mm) thick.
• Push downward into the mortar bed and sideways
against the previously laid block with a slight twisting
motion.
• Tool the mortar joints when they become thumbprint
hard. This will make the mortar joint watertight and
provide a neat appearance.
Application
Preparatory Work
Mixing
Type S Mortar Mix can be mixed by hand or machine.
• Add approximately 4-1/2 quarts (4.3 L) of clean
water into the mixing container for each 80 lb (36.3
kg) bag. Slowly pour the contents of the bag into the
mixing water. Mix until a rm, workable consistency
is achieved.
• If more water is needed, add small amounts at a time
and continue to mix until the desired consistency
is achieved. Do not exceed a total volume of 1-3/4
gallons (6.6 L) of water for each 80 lb (36.3 kg) bag.
Pro-Tip: Color can be added by using concrete and
mortar colorant. To achieve consistent color, use one pint
of colorant per bag of Type S Mortar Mix.
Pro-Tip: Use a level and mason’s line to maintain
correct alignment and joint width throughout the project.
Technical Data
Applicable Standards
ASTM International
• ASTM C270 Standard Specication for Mortar Unit
Masonry.
ASTM (C270) Specication Requirements
Average compressive
strength at 28 days
Water retention,
min. %
Air content
max. %
1800 PSi
(12.4 MPa)
75 12