Operation Manual

Ignition
Ignition Key Slot
Models:
All.
Purpose:
The key is for safety and security. The
key should be inserted prior to starting
an outing, and removed at the conclu-
sion. This is intended to prevent theft
or unapproved use of the boat.
Boats are equipped with an ignition
key, which must be inserted in the igni-
tion key slot and used to activate the
boat’s electrical system. This, in turn,
will allow the boat to be started and op-
erated. The key will be in one of two
(2) positions:
• OFF
• ON (electrical power is ON)
Location:
The ignition key slot is located on the
dash or driver’s arm rest.
Operation:
Insert the key into the key slot. Turn
the key ON. Never start the engine
without having rst run the blower
for at least four (4) minutes. Never
leave the ignition switch in the ON po-
sition without the engine running, as
this will cause the battery to discharge.
Troubleshooting:
If the key will not turn after being in-
serted in the key slot, it is likely to be
the wrong key.
If the key turns but no electrical
power occurs, check the voltmeter for
a reading. If it is lower than 10.5 volts
or does not register, the battery(ies)
require recharging. Use only a Master-
Craft battery charger. DO NOT attempt
to jump start the battery from a vehicle
Page 4-8 2014 MasterCraft Owners Manual • Boat Operations
B O A T O P E R A T I O N S