Use and Care Manual
9
OPTIONAL ACCESSORIES (CON’T)
Optional Plug-In Thermostat Usage
via an elec-
NOTE:
SERVICING INSTRUCTIONS
n.
NOTE: For
generalmaintenancepurposes,theunitmayberapidlydrainedofwaterbyremovingtheoverowttingfromthe
bottom of the unit. This is not adequate draining for winterization (see procedures under Winterization section.)
Annual Maintenance
ed More Often in Areas with Hard Water)
Cleaning
WARNING: Disconnect from electrical power and turn
unitoduringallmaintenance.Turnwatersupplyo
beforeremovingbackforcleaningormaintenance.
CAUTION: In order to maintain UV resistance, do not use
abrasive cleaners on the exterior of the cooler body.
1.
2.
to chip or damage the media while removing. Visually
anomalies.
3. Wash pads with a garden hose. Never use a pressure washer.
4. -
up of dust.
5. Set media in a safe place until all maintenance is complete
.
6.
Use plenty of water to remove algae growth. Clean ar-
growth remains.
CAUTION:Donotuseharshchemicals(likechlorine
bleach) to clean the interior portions of the coole
r.
7. Rinse thoroughly after using any cleaning solutions on
the interior or exterior of the unit.
Water System Pump:
1.
When reattaching the mesh ensure nothing interferes
with free movement of the parts.To avoid premature
g.
2.
Water Float:
3.
-
4. The maximum recommen
ded water level is approximate-
ly
a. REMOVE 4 SCREWS
SECURING BACK
b. PUSH UP TO
RELEASE BACK
c
. DISCONNECT WATER
SUPPLY HOSE
d. PULL BACK GUARD
AWAY FROM UNIT
OPTIONAL
OWNER-INSTALLED
PURGE PUMP
always verify the
reconnected to the
the cooler.
LOCATE MEDIA PEGS AND REMOVE.
OR PULL CLIPS
OFF PEGS FROM
THE INTERIOR.
USING PLIERS,
PULL PLUGS
OUT FROM THE
EXTERIOR.
WATER
SYSTEM
PUMP
WATER
FLOAT