Use and Care Manual
5
Installation in Window
NOTE: We recommend two people for installation.
See page 3 for instructions on unpacking and securing the
fan housing.
1. Remove screen (as needed) and make sure window is opened
interior adjust the exact placement of the unit for aesthetics and
correct lengths of the two accordion spacers (included).
Note: After identifying the position for installation, place
a bubble
levelonthetopoftheexteriorbackoftheunit
andmakeadjustmentstoensuretheunitwillbelevelwhen
installation is complete.
It is recommended to verify unit is
level at various points during installation.
Exterior
2. Closing the window may help hold the unit in place during the
following steps.
Interior
3.
the window structure. Recommended installation is using two
-
as long there are four secure attach points.
NOTE: For easy installation, there are grooves in the
bottomofthefanhousingthattthebrackets.
4. Verify that
5.
adhesive strips and attaching one side to the window casing and
the spacers with silicone or all weather caulk (not supplied).
INSTALLATION PROCEDURES (see illustrations at right)
SPACER TO ENSURE
SQUARE
INSTALLATION
FASTEN TO EXTERIOR
SIDING WITH
MASONRY SCREW
4"
MINIMUM
ITEM D
NOTE
WIDTH
OF FAN
ASSEMBLY LIP
BRACKET
ITEM A
SCREWS
ITEM B
Installation in Wall
1. This cooler is approved for in-wall installation.
Contact
a licensed
contractor to have the cooler installed in an outside wall.
"
46
1
/
8
21
5
/
8
"
21
5
/
8
"
33
5
/
8
12
3
/
8
"
10
5
/
16
"
"
9
3
/
4
"
33
5
/
8
"
19
13
/
16
"
21
5
/
8
"
FRONT VIEW
TOP VIEW
SILL BRACKET
SILL PLATE
SCREW
SCREWS
SPACER TO ENSURE
FLUSH/SQUARE
INSTALLATION
SCREWS
4" MINIMUM
(NOT SUPPLIED)
WINDOW SILL
WINDOW
SCREW
SCREWS
OPTIONAL MOUNTING
TRACKS FOR BRACKETS
BRACKET
LOCATIONS
(UNDERSIDE OF FAN HOUSING)
BRACKET INSTALLATION
POSSIBLE BRACKET
LOCATIONS
WINDOW
WINDOW SILL
Exterior View
Interior View
EXTEND
FULLY
ITEM C
(12 PLACES