SDS

Product Name ALKALINE Zn - Mn DRY BATTERY LR03 Revision date 03-Nov-2017
_
____________________________________________________________________________________________
_
____________________________________________________________________________________________
Page 5
/
10
Skin and body protection Under normal condition of use and handling no special protection is required for
sealed battery. It is recommended to wear appropriate protective clothing when
the battery case is broken.
Other protection Practice good health habits. Eating, drinking and smoking should be prohibited in
areas where this material is handled, stored and processed. Wash hands,
forearms and face thoroughly after handling products, before eating, smoking and
using the lavatory and at the end of the working period.
9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Appearance
Solid
Color
No information available
Odor
No information available
Odor Threshold
Not determined
pH
Not determined
Melting point/freezing point
Not determined
Boiling point / boiling range
Not determined
Flash point
Not applicable
Evaporation rate
Not determined
Flammability (solid, gas)
Not flammable
Flammability Limit in Air
Not applicable
Vapor Pressure
Not determined
Vapor density
Not applicable
Density
Not determined
Relative density
Not determined
Bulk density
Not determined
Specific gravity
Not determined
Water solubility
Insoluble in water
Partition coefficient (LogPow) Not determined
Autoignition temperature
Not applicable
Decomposition temperature
Not determined
Kinematic viscosity
Not determined
Dynamic viscosity
Not determined
Explosive properties
Not an explosive
Oxidizing properties
Not determined
Other information
No information available.
10. STABILITY AND REACTIVITY
Reactivity
Stable under recommended storage and handling conditions (see SECTION 7, handling and storage).
Chemical stability
Stable under normal conditions.
Possibility of Hazardous Reactions
When a battery cell is exposed to an external short-circuit, crushed, modification, high temperature, open flames, it
will be the cause of heat generation and ignition.
Conditions to avoid
Exposed to an external short-circuit, crushed, modification, high temperature, open flames, incompatible materials,
direct sunlight and high humidity.
Incompatible materials
Conductive materials, water, seawater, strong oxidants, strong acid, strong bases, etc.