User Manual

3
3) Remove the male adapter and insert the
cone shaped adapter onto the adapter seat.
4) Follow steps 4-7 of push connect flaring
instructions.
5) Loosen the tightening bar and remove tube. It should look something like the sketch below.
TROUBLESHOOTING
The piston does not seem to advance when the level is pushed.
• Close the relief valve.
• The hydraulic fluid is too cold. Close the relief valve and pump the lever several times to warm
the oil.
The push connect flare does not seem to be formed correctly.
• After the tubing is positioned in the tool the yoke must be rotated into the die before one begins
to squeeze the lever.
• The tightening bar must be very tight.
The tubing is stuck inside the adapter.
• After flaring, you must rotate the yoke counter-clockwise to pull the adapter out of the tubing.
This must be done prior to releasing the tightening bar and attempting to remove the tubing.