User Manual

ManualsBrandsMASTERCOOL ManualsAutomotiveMASTERCOOL 72475-PRC Blue and Silver Universal Hydraulic Flaring Tool Set with Tube Cutter

1

2

3

2

5) Begin squeezing the lever and continue

until the edge of the adapter meets the

die or pumping action shows substantial

resistance.

6) Release the pressure by opening the

relief valve.

7) Grasp the yoke and rotate the tool

counter-clockwise to remove the adapter

from the die.

8) Loosen the tightening bar and remove the

tube. It should look something like the

sketch below.

45˚ DOUBLE FLARING AND METRIC BUBBLE FLARING INSTRUCTIONS

1) Rotate the yoke fully counter-clockwise.

Place the MALE adapter onto the adapter

seat on the end of the piston.

*Remember to use the correct die set.

2) Follow steps 2-7 of push connect

ﬂaring instructions.

If forming 45˚ double ﬂares continue to step

3. If forming metric bubble ﬂare, loosen “T”

handle and remove die blocks and tube.