User manual

TCDS Series User Manual – Rev. 2.0.1 Page 12
Mounting
The TCDS digital time display is designed for table, wall or rack mount. Power and low voltage signal
wiring should be installed according to local electrical codes, so to access the back of the clock.
Do not route power or signal cables between the case and the wall (along the exterior of the
wall), which may pinch the power or signal cable and create a hazardous condition.
Wall Mount Bracket
A wall mounting bracket is supplied which has been designed to fit on either a standard 2”x 4” or 4” x
4” conduit box. Mount the bracket on the wall/conduit box, attach the power cord and RG58 coax
cable and secure the clock to the bracket using the supplied retaining screws.