User manual

Masterclock RC 500 User Manual – v2014.01.01
38
TELNET CURRENT CONFIGURATION/
DEFAULT SETTINGS
Depressing the [Enter] or [Return] key with no number
or letter will retain the current setting.
brightness ─ Default: 4
Show or change the Brightness level of the LED display
and button illumination.
debug ─ Default: Disabled
Show or change the debug output settings.
devicename ─ Default: RC500-xx:xx,
where xx:xx is the last four characters of the MAC
Address.
Show or change the device name.
dhcp ─ Default: Enabled
Show or change the DHCP settings.
dst ─ Default: No
Show or change the Daylight Saving Time settings.
display ─ Default: 24-hour
Show or change the display format.
exit
Exit the current telnet session.
mcast ─ Default: Port 6168
Show or change the multicast control settings.
netstat
Show the device’s network properties.
network
Show or change an IP setting. The device will restart.
ntpclient
Show or change the NTP Network Time Protocol settings.
ntpclientadv
Show or change the NTP Client advanced settings.
password - Default: public
Show or change the password.
ping - Ping to a specified host
This is useful in situations where the communication
path from the network clock to the NTP server is in
question.
properties
Show the device properties.
It is recommended that a robust
naming scheme be developed before
devices are installed to different
locations within an organization.
If Telnet is turned off while in a
Telnet session, the network device will
reboot and the session will end.
To enable Telnet access, either “Reset
to Default” or use WinDiscovery and
from the “Device Settings” window,
click [Communications Control],
[Telnet Control] and check [√]
“Allow Telnet Configuration.”
Current configurations default
settings are displayed.
Depressing the [Enter]/ [Return] key
with no number or letter will retain
the current setting.