User manual

Masterclock RC 500 User Manual – v2014.01.01

When a password is set for a device, each time you click

[OK], [Apply] or [Apply and Close] for that device you

will be asked for the password. You can select the

[Remember this password for the session] button and

you will not be prompted for the password, until you

restart WinDiscovery. Or you can use the Global

Password feature (see below).

If you enter the wrong password and selected the

[Remember this password for the session] checkbox,

you will receive an error upon clicking [OK], [Apply] or

[Apply and Close] to any configuration changes. You can

close the WinDiscovery session to forget the wrong

password(s). However, this will require entering the

password(s) again for each device.

You can also remove the incorrect password entry during

a WinDiscovery session by going to the drop-down menu

for the device (right click to see this) and selecting the

[Forget memorized password] button.

Global Password

The global password feature allows the user to enter a single password for all NTP devices using the same

password. During this session and subsequent sessions of WinDiscovery you will not have to enter the

password.

To use global password, click [Global Password] from the main window of WinDiscovery.

The global password being used must match the password on all the devices being administered.

For example, on any new system being installed, the factory default password on all devices is

“public”.