User manual

Masterclock RC 500 User Manual – v2014.01.01
11
During a routine, press [PAUSE] to freeze the running count. To
continue, press [START] and the routine will continue from its
paused count.
To end a running count before its end number is reached; press
[STOP] and the count will reset back to the preset (i.e. end
number) and hold for the next command.
Count-down
Select the mode of operation by pressing the button labeled
[DOWN].
Enter the start number (preset) by pressing the [HOUR], [MINUTE]
or [SECOND] buttons. With each corresponding button pressed,
the digit on the display will increment.
Press [START] to send a command to the remote display and start
the routine. The display will show the running count. At the end of
the routine, the display on the RC500 and remote display will flash
three times and hold for a command.
During a routine, press [PAUSE] to freeze the running count. To
continue, press [START] and the routine will continue from its
paused count.
To end a running count before its end number (i.e. 0) is reached;
press [STOP] and the count will reset back to the preset (i.e. start
number) and hold for the next command.