User manual

Masterclock RC 500 User Manual – v2014.01.01

Control Button Details

Control Button Detail

THREE BUTTON SETS ON THE FACEPLATE

The “MODE” set controls whether you want simple clock

operation, count-up, or count-down.

The “SET” set controls the hour, minute and second.

The remaining (lower row) set starts, pauses and stops

the other two modes.

Examples

There are four modes of operation.

 Clock

 Count-up

 Count-down

 Count to Time

Below are a few scenarios of how to program and run a routine.

Clock

Press [CLOCK] to exit the “Up” or “Down” mode or the standalone

configuration menu.

Please refer to the “Configuration” section of this

document for details on the standalone menu.

Count Up

Select the mode of operation by pressing the button labeled [UP].

Enter the end number (preset) by pressing the [HOUR], [MINUTE]

or [SECOND] buttons. With each corresponding button pressed,

the digit on the display will increment.

Press [START] to send a command to the remote display and start

the routine. The display will show the running count. At the end of

the routine, the display on the RC500 and remote display will flash

three times and hold for a command.

The combination of

LED display and

illuminated buttons

indicate the selected

mode and current step

being performed.