User manual

Masterclock NTDS-A User Manual – Original – 2013-04-25

Installing the device driver Masterclock Digital Display

USB DEVICE DRIVER

A USB type B port has been included on the rear cover of the

clock to configure the clock to allow for firmware upgrades,

corrections and enhancements.

INSTALLING THE DEVICE DRIVER

First, power-on the clock. Next, use a USB cable (not supplied)

and connect the clock to your PC. The Windows Plug and Play

manager will detect a new USB device and request device

drivers. If Windows is unable to install the USB device drivers,

the system will send an alert.

Open “Device Manager” and locate [Time Code Display] listed

under “Other devices.” Right click the device and click on

[Update Driver Software.] This will need to be performed for

both USB device drivers (i.e. COM and BUS).

There are two locations for the USB Device Driver:

1. C:\ Program Files\Masterclock\WinDiscovery \Drivers\

2. CD labeled, “Products” X:\Products\NTDS-A\Drivers\

Note: “X” is the CD/DVD drive letter of your Windows PC.

USB A cable end

(to computer)

USB B cable end

(to clock)

USB B port on clock

(back panel view)

Device Manager

Device Manager with correct USB Device Driver