Installation manual

__________________________________________________________________________________________________
__________________________________________________________________________________________________
Operator Manual for MC-4044 Series 5 G/93040 Issue 6 Page 4
Change the diversion number
1. Press 2 (or 5 to change the second diversion number)
2. After the prompt has finished, enter the required number
3. Press #
4. The new number will then be replayed.
The programming can be done in any sequence. Once programming is completed, replace the receiver and
MASTERCALL will hang up in 5-20 seconds. Do not test the diverter until 20 seconds have elapsed.
RECORDED VOICE ANNOUNCEMENTS (RVA)
MASTERCALL can play a digitally recorded announcement to the caller while the call is being re-directed to another
number. MASTERCALL can also announce the origin of the diverted call to the party receiving calls. The Digital Voice
Announcer represents the latest in digital EPROM and EEPROM based voice announcements.
The Recorded Voice Announcements are grouped as follows:
Standard Diversion Announcement
A standard announcement, "Please hold the line...ring ring...", is played to the caller while the call is being re-directed to
the pre-programmed diversion number.
To Enable The Standard Diversion Announcement (from the Keypad):
1. Press 71.
2. The display reads ‘on’.
To Disable The Standard Diversion Announcement (from the Keypad):
1. Press 70
2. The display reads ‘off’.
Personalised Diversion Announcement (Optional)
A personally recorded announcement up to 16 seconds in length (recordable from any telephone)is played to the caller
while the call is being re-directed to the pre-programmed diversion number. This feature will only work if MASTERCALL
is fitted with the PRVA daughter board.
To Record The Personalised Diversion Announcement (by Remote Control):
1. Call line 2 of MASTERCALL, listen for one ring, hang up and wait a few seconds.
2. Redial line 2 and wait for greeting "Hello, this is MASTERCALL, please enter PIN".
3. Enter your four digit PIN.
4. Press 75
5. Listen for "Record Announcement".
6. Dictate your announcement clearly then press #. The announcement will be replayed. Repeat steps 4 - 6 if necessary.
The announcement is automatically enabled.
7. To replay the announcement you can press 74.
8. Enter other programming changes or hang up.
Summary: Enter PIN, 75...record announcement...#, hang up.
To Enable The Personalised Diversion Announcement (from the Keypad):
1. Press 72.
2. The display reads ‘on’.