Installation manual

__________________________________________________________________________________________________
__________________________________________________________________________________________________
Operator Manual for MC-4044 Series 5 G/93040 Issue 6 Page 3
Diversion If No Answer
MASTERCALL can be programmed to divert after a preset delay. When MASTERCALL is in the deactivated state and
there is an incoming call which is not answered after the delay, MASTERCALL will process the call and then resume the
deactivated state after the call.
The delay before diversion is entered as a 3 digit number which is the delay in seconds.
1. * 6705 #
2. * 25 xxx * #, where xxx is the delay in seconds
• To disable delayed diversion, program xxx as 000.
Please Note: Diversion If No Answer is not compatible with Auto Turn On. Auto Turn On, if set, will override Diversion
If No Answer.
Auto Turn On
MASTERCALL can be programmed to automatically turn on and divert a call after a preset delay. When MASTERCALL
is in the de-activated state, and the incoming telephone rings, MASTERCALL will activate and process the diversion
request and remain activated after the call. The delay before auto turn on is entered as a 3 digit number which is the turn on
delay in seconds.
1. * 6705 #
2. * 24 xxx * #, where xxx is the delay in seconds
• To disable auto turn on, program xxx as 000.
Remote Control Personal Identification Number (PIN)
Access .to remote programming is protected by a PIN which is stored via the keypad. This four digit number is
programmed by pressing the following keys.
1. * # xxxx #, where xxxx is the 4 digit code
• This number cannot be recalled, so if it is forgotten, a new number must be stored.
REMOTE CONTROL OPERATION
MASTERCALL can also be programmed remotely from another telephone. Operation is summarised here. Please note that
ALL programming operations can be performed by Remote Control. So after having accessed Remote Control, simply
program by phone as you would at the Keypad.
To Access Remote Control
1. Dial the line 2 telephone number.
2. Listen for one ring tone then hang up.
3. Wait a few seconds then redial the line 2 telephone number.
4. Wait for approximately 2 rings and your call will be answered by MASTERCALL.
5. After the message has finished, enter the PIN number using a DTMF dialling telephone or a portable DTMF encoder.
Activate/deactivate MASTERCALL
You will be prompted by the digitised voice.
1. To change the divert status between on/off, press 1.
Confirmation of diversion number(s)
1. Press 2 then #.
2. The diversion number will be replayed.