Installation manual

__________________________________________________________________________________________________
__________________________________________________________________________________________________
Operator Manual for MC-4044 Series 5 G/93040 Issue 6 Page 2
SECTION 3 - PROGRAMMING INSTRUCTIONS
AT THE KEYPAD
The operation of the diverter at the keypad is detailed in this section. As the diverter is normally ‘asleep, ie. the
microprocessor is not running, the first key should be pressed for approximately half a second to ensure correct function.
The ‘awake’ state is indicated by the decimal point on the 7 segment display.
MASTERCALL Activate/Deactivate
By pressing 1, the MASTERCALL divert state is toggled. The activated state is indicated by the green ‘Divert’ LED on the
front panel. When this LED is on, the activated state is selected and all incoming calls will be diverted to the pre-
programmed number.
Keypad Enable/Disable
The keypad can be disabled and enabled via the entry of a special code. When enabled the keypad is used to perform all
functions detailed here. When the keypad is disabled, the only keys that work are the 1 key to turn the diverter on and off,
and the following code to enable the keypad.
The sequence to enable/disable the keypad is as follows.
To enable: Press * 3333 #
To disable: Press # 3333 #
Diversion Number
The number that the diverter dials is programmed via the keypad. To enter a new diversion number you enter:
2 nnnn nnnn #, where nnnn nnnn is the required diversion number (up to 20 digits).
Second Diversion Number
If the first number is unanswered or engaged, a second number can be tried. To enter a new second diversion number you
enter:
5 nnnn nnnn #, where nnnn nnnn is the second number if required (up to 20 digits).
Identification Tone
When a diverted call is answered, MASTERCALL can send a string of DTMF digits. These tones can be decoded at the
receiving end in order to identify which diverter is calling. This feature is useful for live answering and paging services.
To activate and enter the DTMF identification tones, press:
83 nnnn nnnn #, where nnnn nnnn are the required DTMF digits (up to 20 digits).
To deactivate the ID tone, press 80.
Notes
1. If no second diversion number is required, you MUST enter ‘0’ as the second number.
2. A dialling pause can be entered by pressing * #.
3. A star (*) can be entered by pressing * *.
4. A hash (#) can be entered by pressing # #.
5. To check the diversion number(s) press 2 # or 5 #.
6. To check the Identification digits, press 83 #.
Call Counter
Press 3 and MASTERCALL will display the number of successful diversions (0-999).
Press 3 then * if you wish to reset (clear) the counter.