Installation manual

__________________________________________________________________________________________________
__________________________________________________________________________________________________
Operator Manual for Mastercall Alarm Dialer D2K Ref.: SCN99213 Page 1
MASTERCALL MC-4044 SERIES 5
ALARM DIALER
Mastercall can be configured to operate as an intelligent Alarm Dialer.
A normally open (NO) voltage-free relay contact closure is used to trigger Mastercall to dial up to eight different telephone
numbers until one is answered. When answered, Mastercall plays the personal recorded message to the called party.
A latched contact closure from an alarm system causes Mastercall to start dialing the first of up to eight pre-programmed
telephone numbers. If, when answered, Mastercall detects a DTMF 9 from the called party, the dialing sequence stops. If
no DTMF 9 is detected, either during or within ten seconds after the announcement, the dialing sequence continues.
TO PROGRAM THE EIGHT TELEPHONE NUMBERS
Check first diversion number 21 #
Check second diversion number 22 #
Check third number 23 #
Check fourth diversion number 24 #
Check fifth diversion number 25 #
Check sixth diversion number 26 #
Check seventh diversion number 27 #
Check eighth diversion number 28 #
Change first diversion number 21 nn nnnn nnnn #
Change second diversion number 22 nn nnnn nnnn #
Change third diversion number 23 nn nnnn nnnn #
Change fourth diversion number 24 nn nnnn nnnn #
Change fifth diversion number 25 nn nnnn nnnn #
Change sixth diversion number 26 nn nnnn nnnn #
Change seventh diversion number 27 nn nnnn nnnn #
Change eighth diversion number 28 nn nnnn nnnn #
To cancel number 2x 0 #, where x = 1 → 8.
TO RECORD THE PERSONAL IDENTIFICATION ANNOUNCEMENT
A personally recorded announcement (recordable from any telephone), announcing the nature of the alarm (and how to
stop dialing), is played to the receiving party when they first answer an alarm call. For example: "Melbourne office cabinet
temperature high alarm, your attendance is required, please press 9 to acknowledge".
To Record the Personalised Identification Announcement (by Remote Control):
1. Call line 2 of MASTERCALL, listen for one ring, hang up and wait a few seconds.
2. Redial line 2 and wait for greeting "Hello, this is MASTERCALL, please enter PIN".
3. Enter your four digit PIN (preset to 1234).
4. Press 85.
5. Listen for "Record Announcement".
6. Dictate your announcement clearly then press #. The announcement will be replayed. Repeat steps 4 - 6 if necessary.
The announcement is automatically enabled.
7. To replay the announcement you can press 84.
8. Enter other programming changes or hang up.
Summary: Enter PIN, 85...record announcement...#, hang up.