Installation manual

__________________________________________________________________________________________________
__________________________________________________________________________________________________
Operator Manual for MC-4044 Series 5 G/93040 Issue 6 Page 16
FACTORY OPTION CODES
Using either the MASTERCALL Keypad or by Remote Control, enter Factor y master access code * 67 7096 50 #, listen
for "Please enter command"
COMMANDS
* nn where nn is option code number
n = entry
# = scroll down to next option number
* * = abandon (do not save any changes)
* # = store (save any changes)
After either storing or abandoning program changes you can continue to make other programming changes, press # # to
end, or simply hang up.
OPTION CODE ENTRY RESPONSE
NUMBER STORAGE * 80 "80 is n, please enter command
Range 1 → 8 Numbers 2 2
NUMBER SELECT * 81 "81 is n, please enter command"
Fixed 1 1
Selectable 2 2
NUMBER TRY * 82 "82 is n, please enter command"
Multi 1 1
Single 2 2
IN LINE NUMBER SELECT * 83 "83 is n, please enter command"
Same number dialled on both lines 1 1
In line select 2 2 (Incoming line selects the number to be dialled)
REMOTE CONTROL * 84 "84 is n, please enter command"
No remote access 1 1
Remote control access 2 2
CONFERENCE FACILITY * 85 "85 is n, please enter command"
No conference 1 1
Conference 2 2
CALL COUNTERS * 86 "86 is n, please enter command"
Up to 99 x 2 counters 1 1
Up to 9999 2 2
PROCESSOR POWER MODE * 87 "87 is n, please enter command"
Sleep between calls and programming 1 1
Powered continuously 2 2
MODEL * 88 "88 is n, please enter command"
Australia 00 00
Eaglefone 01 01
Belgium 02 02
South Africa 03 03
Indonesia 04 04
Suffix Selection 05 05
Germany 06 06
PABX ‘EXTENDER’ * 89 "88 is n, please enter command"
Off 1 1
Extender 2 2
Extender with Call Back 3 3
DSI-5 Extender Interface 4 4