Installation manual

__________________________________________________________________________________________________
__________________________________________________________________________________________________
Operator Manual for MC-4044 Series 5 G/93040 Issue 6 Page 9
TONE DETECTION AND AMPLIFIER CODES
Using either the MASTERCALL Keypad or by Remote Control, enter Tone Detection access code * 67 05 #, listen for
"Please enter command"
COMMANDS
* nn where nn is tone parameter code number
nnn = entry
# = scroll down to next tone parameter
* * = abandon (do not save any changes)
* # = store (save any changes)
After either storing or abandoning program changes you can continue to make other programming changes, press # # to
end, or simply hang up.
________________________________________ AUSTRALIA
TONE PARAMETER CODE DEFAULT VALUE PERIOD (ms) RESPONSE
Entry Actual Nominal
BUSY OFF MIN * 00 007 224 225 "00 is nnn, enter command"
BUSY OFF MAX * 01 017 544 550 "01 is nnn, enter command"
BUSY ON MIN * 02 007 224 225 "02 is nnn, enter command"
BUSY ON MAX * 03 017 544 550 "03 is nnn, enter command"
NU OFF MIN * 04 012 384 400 "04 is nnn, enter command"
NU OFF MAX * 05 018 576 600 "05 is nnn, enter command"
NU ON MIN * 06 062 1984 2000 "06 is nnn, enter command"
NU ON MAX * 07 094 3008 3000 "07 is nnn, enter command"
RING 1 OFF MIN * 08 004 128 130 "08 is nnn, enter command"
RING 1 OFF MAX * 09 008 256 260 "09 is nnn, enter command"
RING 1 ON MIN * 10 008 256 260 "10 is nnn, enter command"
RING 1 ON MAX * 11 015 480 480 "11 is nnn, enter command"
RING 2 OFF MIN * 12 050 1600 1600 "12 is nnn, enter command"
RING 2 OFF MAX * 13 075 2400 2400 "13 is nnn, enter command"
RING 2 ON MIN * 14 008 256 260 "14 is nnn, enter command"
RING 2 ON MAX * 15 015 480 480 "15 is nnn, enter command"
Notes:
• Entry = tone length in milliseconds divided by thirty two unless otherwise noted
• There are eight values for RING TONE, thus allowing two OFF times and two ON times. Where only one OFF and/or
ON time is required, set values for both RING 1 and RING 2 to the same. always set the RING 1 values to the shorter
values when two tone lengths are involved.