Installation guide

__________________________________________________________________________________________________
Technical Guide for Office Extender T/95081 Issue 5 Page 5
__________________________________________________________________________________________________
ACTIVITY CODES ON THE MONITOR DISPLAY
0. = Silence.
1. = Busy tone.
2. = Modulated dial tone.
3. = Number Unobtainable (NU).
4. = Speech.
5. = Steady tone.
6. = No progress or ‘random’ busy tone detected.
7. = Ring tone.
8. = Connecting caller to operator or loop current loss/line reversal.
A. = Carrier tone to H.I.M.
STATUS LED
Off = No session established.
Slow flash = Session established but no call in progress.
On = Session established and call in progress.
Fast flash = Session established but telecommuter has hung up and will be redialled.
USER ERROR CODES
21 = Operator number one currently ‘in session’.
22 = Operator number two currently ‘in session’.
23 = Operator number three currently ‘in session’.
24 = Operator number four currently ‘in session’.
25 = Operator number five currently ‘in session’.
26 = Operator number six currently ‘in session’.
27 = Operator number seven currently ‘in session’.
28 = Operator number eight currently ‘in session’.
Note: The Office Extender can be programmed to allow other operators to take over the current session.
REMOTE CONTROL
All system programming functions can be performed from any telephone. This facility provides the system administrator
with full remote control. Access to remote control is protected by a Master PIN.
To change the Master PIN Number (from the Extender Keypad)
Press * # 0 mmmm #, where mmmm = Master PIN.
To Access Remote Control
1. Dial Line 2 of the Extender and wait for answer.
2. Press *
3. Enter the Master PIN (default = 1234)
4. Program as you would from the keypad. Programming will be voice prompted.