Installation guide

__________________________________________________________________________________________________
Technical Guide for Office Extender T/95081 Issue 5 Page 2
__________________________________________________________________________________________________
OPERATOR OVERRIDE * 69 “69 is n, please enter command”
No
1 1
Yes 2 2
DIAL TONE DETECT * 70 “70 is n, please enter command”
5 sec wait for dial tone and re-loop if none
1 1
3 sec wait for dial tone (blind dial) 2 2
CONTINUOUS TONE DISCONNECT * 71 “71 is n, please enter command”
Keep connection on continuous tone
1 1
Disconnect on continuous tone 2 2
LINE TEST FOR DISCONNECTION * 72 “72 is n, please enter command”
Loop break every 10 seconds of silence 1 1
No loop break
2 2
SPARE * 73 & * 74 “73/74 is n, please enter command”
CALL PROGRESS TEST NUMBERS * 75 “75 is n, please enter command”
Off
1 1
On 2 2
LINE REVERSAL/LOOP CURRENT
LOSS DETECT * 76 “76 is n, please enter command”
Yes - for connect and disconnect 1 1
No 2 2
Yes
- for disconnect only 3 3
Yes - for connect only 4 4
ERROR MESSAGE NUMBERS * 77 “77 is n, please enter command”
Off
1 1
On 2 2
SPARE * 78 “78 is n, please enter command”
BUSY COUNTER FOR
DISCONNECTION * 79 “79 is n, please enter command”
1 → 8 bursts 7 7
MAX. RING VOLTAGE OFF TIME * 80 “80 is n, please enter command”
1 → 8 Seconds 6 6
RANDOM BUSY DETECT * 81 “81 is n, please enter command”
Yes
1 1
No 2 2
HOOK FLASH * 82 “82 is n, please enter command”
100 ms
1 1
250 ms 2 2
500 ms 3 3
1000 ms 4 4
(* 67 7096 00 # sets all options to the factory default, Extender responds “Thank you, please enter command”. Take care
not to unintentionally enter this command !!!) Factory presets are Underlined. These can and should be changed to suit the
application.