Installation manual

__________________________________________________________________________________________________
__________________________________________________________________________________________________
Operator Manual for Mastercall MC-4044 Series 8 G99120A Issue 3 Page 5
Personalised Identification Announcement (Optional)
A personally recorded announcement (recordable from any telephone),announcing from where the diverted call has
originated, is played to the receiving party when they first answer a diverted call. For example: “Melbourne Office”. This
feature will only work if MASTERCALL is fitted with the PRVA hardware.
To Record the Personalised Identification Announcement (by Remote Control):
1. Call line 2 of MASTERCALL, listen for one ring, hang up and wait a few seconds.
2. Redial line 2 and wait for greeting “Hello, this is MASTERCALL, please enter PIN”.
3. Enter your four digit PIN.
4. Press 85.
5. Listen for “Record Announcement”.
6. Dictate your announcement clearly then press #. The announcement will be replayed. Repeat steps 4 – 6 if necessary.
The announcement is automatically enabled.
7. Enter other programming changes or hang up.
Summary: Enter PIN, 85…record announcement…#, hang up.
To Disable the Personalised Identification Announcement (from the Keypad):
1. Press 80.
2. The display reads ‘off’.
Notes:
The Diversion Announcement and the Identification Announcement can be independently enabled or disabled from the
Keypad or by Remote Control from any remote telephone. Recording the announcements can only be done by Remote
Control.
KEYPAD ENABLE/DISABLE
The keypad can be disabled and enabled via the entry of a special code. When enabled the keypad is used to perform all
functions detailed here. When the keypad is disabled, the only keys that work are the 1 key to turn the diverter on and off,
and the following code to enable the keypad.
The sequence to enable/disable the keypad is as follows.
To enable the Keypad (to unlock it): Press * 3333 #. UnLOC is displayed.
To disable the Keypad (to lock it): Press # 3333 #. If any key other than 1 or # is pressed, LoC will be displayed
AUTO-TURN ON
MASTERCALL can be programmed to automatically turn on and divert a call after a preset delay. When MASTERCALL
is in the de-activated state, and the incoming telephone rings, MASTERCALL will activate and process the diversion
request and remain activated after the call. The delay before auto turn on is entered as a 3 digit number which is the turn on
delay in seconds.
1. * 6703 #
2. * 24 sss * #, where sss is the delay in seconds
• To disable Auto-Turn On, program sss as 000.