User Manual

9
TROUBLESHOOTING SOLUTIONS: “CAUSES” LOW OR NO FLOW/VAPOR LOCK/EXCESS FLOW
Symptom Cause Possible Solution
Burner doesn’t light after pressing
ignitor button
Low/no gas ow 1. Turn burner control knobs to “OFF” position.
2. Turn gas cylinder valve knob to OFF.
3. Disconnect regulator from cylinder to relieve vapor
lock.
4. Reconnect regulator to cylinder by hand turning
until tight.
5. Slightly open the gas cylinder valve slowly and then
open further by turning 1 full turn.
6. You are now ready to light the smoker.
7. Turn the burner control knobs to high and light with
ignitor.
Vapor lock at coupling nut
to LP cylinder
Low ame output Excess ow valve tripped
Vapor lock at coupling nut/
LP cylinder connection
Flames blow out Excess ow valve tripped
Slower than expected cooking times Vapor lock
* Also see Troubleshooting solutions: “Causes” Low or No Flow/Vapor Lock/Excess ow below.
• BEFORE ASSEMBLY READ ALL INSTRUCTIONS CAREFULLY.
• ASSEMBLE UNIT ON A CLEAN, FLAT SURFACE.
• TOOLS NEEDED: Adjustable wrench, Phillips head screwdriver
• APPROXIMATE ASSEMBLY TIME: 25 minutes
** It is possible that some assembly steps have been completed in the factory. **
DO NOT RETURN TO RETAILER. For assembly assistance, missing or damaged parts
please contact Customer Service at 1300 174 876.
Please have model number and serial number available when calling.
These numbers are located on the silver label on the back of unit.
STOP!