Specifications

2
IMPORTANT NOTICES
• Read this manual before installing your Master Controller 2.0 system.
Keep the manual and refer to it before doing any service on the
equipment. Failure to do so may result in personal injury or waive
warranty of damaged equipment.
• Modifications to existing equipment are subject to approval by Master-Bilt
and must be explicitly written. There are no implied flexibilities designed into
this product.
• The following points apply unless overwritten and approved by the Master-
Bilt engineering department:
o Maximum distance of wires between the evaporator and the Master
Controller 2.0 MUST not exceed 40 ft.
o The Master Controller 2.0 MUST be mounted on the neighborhood of
the vestibule entrance door for below -40
o
F extra low temp freezer
o All sensor wires MUST be in separate metal conduit from power wiring
and control wiring for below -40
o
F extra low temp freezer
• Due to continuous product enhancements, Master-Bilt reserves the right to
make engineering changes and change specifications for product
improvement without notice.