Owner manual

ManualsBrandsMasterbuilt ManualsKiln30-inch Electric Digital Smokehouse Black w/ Top Control (20070910) HEATING ELEMENT REPLACEMENT

Heating Element Replacement Instruction for

20070710, 20070810, 20070910 Electric Smokers

PARTS AND HARDWARE

ITEM

NUMBER

QUANTITY

DESCRIPTION

1 1 Replacement Element

2 1 Gasket

3 2 Replacement Wire Assembly

4 2 Wire Nuts

5 2 Element Screws

Required Tools: Short Phillips head Screwdriver

Wire Stripper

• ALWAYS REMOVE PLUG FROM OUTLET BEFORE SERVICING!

• MAKE SURE UNIT HAS FULLY COOLED TO AVOID BURNING!

• EDGES MAY BE SHARP. USE CAUTION TO AVOID INJURY!

!CAUTION!

090126-04SS

Summary of content (4 pages)

PAGE 1
Heating Element Replacement Instruction for 20070710, 20070810, 20070910 Electric Smokers Required Tools: Short Phillips head Screwdriver Wire Stripper PARTS AND HARDWARE ITEM NUMBER QUANTITY 1 1 Replacement Element 2 1 Gasket 3 2 Replacement Wire Assembly 4 2 Wire Nuts 5 2 Element Screws DESCRIPTION 2 3 1 4 5 !CAUTION! • ALWAYS REMOVE PLUG FROM OUTLET BEFORE SERVICING! • MAKE SURE UNIT HAS FULLY COOLED TO AVOID BURNING! • EDGES MAY BE SHARP.
PAGE 2
*Disconnect from power source and allow unit to fully cool before replacing heating element. Step 1: Remove woodchip loader from unit Step 3: Remove 4 screws from the woodchip housing (A) and detach from inside smoker to expose heating element as illustrated. A Step 2: Remove cooking grates, woodchip holder and drip pan out of smoker. Caution! Sharp edges may cause injury! Before continuing, be sure to note that edges of thin sheet metal in this step could cause injury.
PAGE 3
Step 5: Unscrew heating element support screws and detach rubber housing from rear enclosure. Step 6: Inside unit, pull heating element from back of unit, pulling away gasket from element bracket and exposing ground wire. Remove ground wire from heating element as shown. Step 7: Connect ground wire to new heating element in reverse order of step 6. *Steps 8-9 require assistance.
PAGE 4
Step 11: If female spades need to be replaced, cut the existing spade off, then strip insulation back 3/8” using wire stripper. 3/8 E X S I TI Step 12: Attaching bare replacement wiring assembly to existing wire from body, join the two bare ends of wire together and twist until wires are held securely to each other. Place wire not over the two wires and twist wirenut until secure on both wires.