Instructions / Assembly

ENSAMBLAJE
PASO 11 Coloque el tazón de agua (19) bajo la última rejilla del ahuma- dor. Fije el protector solar (7) sobre el panel de control (4).
PASO 12 Coloque la bandeja de trozos de madera (13) y la bandeja de goteo (25) dentro del ahumador como se muestra. Inserte el cargador de trozos de madera (24) en la parte lateral del ahumador. El ensamblaje está completo.
11
7
19
4
25
13
24
ASSEMBLY
STEP 6 Carefully position smoker as shown. Attach rear handle (5) to back of smoker body (2) using phillips screws (A) as shown.
Note: Do not lift unit by rear handle.
17
2
A
8
STEP 5 Insert adjustable screw leg (20) through bottom of side panel (17) as shown, and into smoker body. Repeat step on opposite side for remaining adjustable screw leg. Note: When unit is upright, set adjustable screw leg height by turning clockwise/counterclock- wise, so that smoker is level. Once level, secure leg positions by tightening tension nuts.
TENSION NUT
20
5