Instructions / Assembly

ENSAMBLAJE
• ANTES DE ENSAMBLAR LEA TODAS LAS INSTRUCCIONES CUIDADOSAMENTE. • ENSAMBLE LA UNIDAD SOBRE UNA SUPERFICIE LIMPIA Y PLANA.
Paso 2 Afl oje el perno con alas (2) [El
perno con alas no tiene que estar completamente retirado]. Inserte las patas de extensión (3) en el sostenedor de las patas en el marco de la hornilla (1) y asegure con el perno con alas (2). Paso 1 Alinee el lado plano del inser- to de la perilla de control de la válvula (5) icon el lado plano del eje de la válvula de control (6). Empuje fi rmemente en su lugar hasta que esté seguro.
3
1
2
5
6
11
1. Check the regulator control valves to be certain they are in the OFF position before connecting
to the gas cylinder. Perform soapy water test before each use (Page 5).
2. Remove burner covers. 3. Turn gas cylinder valve ON. 4. To ignite, turn burner knob to high. 5. Press ignitor button. 6. If burners do not ignite within 10 seconds, release ignitor button and turn burner knob to OFF
position. Wait 5 seconds and repeat Steps 2 through 4.
7. To match light, place a long match into matchstick and light. 8. Place matchstick close enough to burner to ignite. 9. Slowly turn on the one control valve until the burner lights. (If burner does not light within 5
seconds, turn regulator control valve OFF, then the gas cylinder valve OFF.) Wait 5 minutes for fumes to diminish before relighting. If the fl ame is blown out wait 5 minutes for fumes to
diminish before relighting.
10. After the burner is lit, adjust the valve until the fl ame decreases to Low, Med or High. Use the
air shutter on the burner to adjust the fl ame until it turns blue.
11. Fill Pot with water or oil. DO NOT fi ll pot more than 1/3 of the pots full capacity. This will help
avoid dangerous boil-overs. Note: DO NOT place your empty pot over the open fl ame. This
will damage pot.
12. Bring your water or oil to the desired temperature by adjusting control valve. Oil should never
exceed 400°F. Oil will ignite at 550°F to 700°F.
13. Always use a thermometer when frying. 14. After each use, fi rst turn the control valves OFF, then the gas cylinder OFF. Always allow gas
cooker stand and pot with water or oil to cool completely before touching, moving, or storing.
15. Do not store or use gasoline or other liquids with fl ammable vapors in the vicinity of this or any
other appliance.
BURNER LIGHTING INSTRUCTIONS
Match Light
Ignitor Button
WARNING
Do Not allow hose to
come in contact with
appliance. HOT surfaces
may damage hose
causing a leak and fire.
WARNING
Remove burner covers
before operating
applicance.
8