Instructions / Assembly

GAS VALVE OPERATION
Before using, turn the gas cylinder ON fi rst, then one control valve ON and light. After use, turn control valves OFF fi rst, then the gas cylin-
der OFF. The control valve is used to adjust the burner fl ame.
Adjust air shutter to the burner until the burner fl ame is as blue
as possible
COUNTER
CLOCKWISE
ON
OFF
CLOCKWISE
Burner
Air Shutter
Type 1 Regulators will have a hook as shown. The Regulator Hook is used to keep the regulator off the ground when removed from the LP cylinder. Attach to appliance as shown.
CONTROL VALVE
FLAME ADJUSTMENT
WARNING
DANGER
• The use of alcohol, prescription or non
prescription drugs may impair the consumer’s ability to properly assemble or safely operate the appliance.
• Do not obstruct flow of combustion and
ventilation. Keep the ventilation opening(s) of the cylinder enclosure free and clear of debris.
• The installation of this appliance must conform
with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54, Storage and Handling of Liquefied Petroleum Gases ANSI/NFPA 58 or CSA B149.1, Natural Gas Installation Code
• The LP-gas cylinder being used must be
constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation (DOT) CFR 49 or the National Standards of Canada, CAN/CSA- B339, Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods.
Gas Cylinder Storage, Placement and Filling:
• Do not store a spare LP-gas cylinder under or
near appliance. The gas cylinder safety relief valve may overheat, allowing gas to release causing an intense fire with risk of death or serious injury.
• Never fill the cylinder beyond 80 percent full. Over
filled cylinders can release gas.
• If you smell, hear or see gas escaping
immediately get away from the gas cylinder and call the Fire Department; a fire causing death or serious injury may occur.
• Place a dust cap on cylinder valve outlet
whenever the cylinder is not in use. Only install the dust cap on the cylinder valve outlet that is provided with the cylinder. Other caps or plugs may cause leaks.
Gas Cylinder Storage and Appliance Check:
• Cylinders must be stored outdoors, out of reach of children and must not be stored in a
building, garage, or any other enclosed area.
• Before each use check all nuts and bolts to be sure that they are tight and secure. • Before each use inspect gas hose for any signs of damage. • Before each use preform soapy water test.
7
Antes de cada uso revise todos los accesorios de montaje
para asegurarse que estén firmes y seguros.
ADVERTENCIA
Paso 4 Forme el lado izquierdo y derecho de la protección contra el viento (12) alrededor del anillo de seguridad del marco de la hornilla (1) y deslice las pestañas restantes a su lugar.
12
Paso 3 Asegure en la parte posterior las dos pestañas de montaje de la protección contra el viento (12) en el marco de la hornilla doble (1) tal como se muestra.
12
1
1
ENSAMBLAJE
12