Instructions / Assembly

Almacenamiento de las patas de extensión: Meta las patas de extensión (3) en cada abrazadera de la parte posterior del marco de la hornilla doble (1) como se muestra.
CÓMO GUARDAR LAS PATAS
LA UNIDAD AHORA ESTÁ LISTA PARA SER USADA, ¡DISFRÚTELA!
13
ENSAMBLAJE
1
3
REGULATOR, BURNER AND GAS VALVE CONNECTION & OPERATION
• Inspect hose before each use. If there are signs of wear, cuts,
or leaks, replace unit. DO NOT USE.
• Inspect burner before each use. Check burner and burner ven-
tura tube for insects and insect nests. A clogged tube can lead to a fi re beneath appliance.
• Connect hose regulator to LP Gas Cylinder
1. Make sure gas cylinder valve is closed. Turn knob clockwise
until it stops.
2. Make sure control knob on grill is in the “OFF” position. 3. Remove protective cap from gas cylinder and coupling nut if
applicable.
4. Center and insert regulator nipple into valve outlet on gas
cylinder as shown in fi gure on the left. Turn regulator cou-
pling nut clockwise until it stops. DO NOT OVER TIGHTEN.
• Per
form Soapy Water Test.
• To use, turn gas cylinder ON, turn burner control knob count-
er-clockwise and push ignitor button to light.
• If ignition does not take place within fi ve seconds, turn gas
control valve to “OFF” position and wait fi ve minutes and repeat lighting procedures. If ignition still does not occur, see match light directions below.
• After use turn burner control knob OFF, then turn gas cylinder
OFF.
• Burner control knob adjusts burner fl ame. Turn control knob
clockwise SLOWLY to increase fl ame. Turn control knob count-
er-clockwise to decrease fl ame and shut fl ame off.
•
Visually check burner fl ame. A CORRECT FLAME should be blue with a small amount of yellow at the tip. An INCORRECT FLAME is excessively yellow and irregular. If an incorrect fl ame occurs, turn burner control knob to “OFF” position, turn off regulator and propane tank. Allow unit to cool and then clean burner. Let burner completely dry before re-lighting
.
CLOCKWISE
COUNTER
CLOCKWISE
17.75”
(45cm)
APPROX.
12.25” (45cm)
APPROX.
YELLOW
INCORRECT
CORRECT
BLUE
Note: Use 20LB (9kgs) gas cylinder that has a protective collar with this unit.
Cylinder NOT included with this unit.
6
MATCH LIGHT INSTRUCTIONS
1. Read all instructions and warnings before lighting. 2. Check gas control valve and gas cylinder valve to be
certain it is in OFF position before connecting to gas cylinder. Perform soapy water test before each use.
3. Turn gas cylinder valve on, turn gas control valve on. 4. With a lit match in matchstick, place match close
enough to burner to ignite.
5. After each use, fi rst turn gas control valve off, then
gas cylinder valve off. Always allow unit to cool completely before touching, moving or storing.
6. Store matchstick as illustrated when not in use.