User's Manual

Problem: Cannot make meat selection.
Solution: May be in timer mode. Check to make sure that the Handheld
Unit (Receiver) is in the thermometer mode by pressing MODE button.
Problem: No data link between Handheld Unit (Receiver) and Base Unit
(Transmitter).
Solutions: Check to make sure that both units are turned ON while in
close proximity to one another.
Check batteries for replacement.
1. Hand wash probe with soap and water.
2. Do not immerse probe in water while cleaning.
3. Dry immediately.
4. Do not wash Handheld Unit (Receiver) or Base Unit (Transmitter).
5. Unit is not Dishwasher Safe.
TROUBLE SHOOTING
CLEANING INSTRUCTIONS
1. Meat probe and wire are very hot while in use.
2. Always use a heat-resistant glove when handling meat probe or probe
wire while in use. Do not touch with bare hands.
3. Do not expose Handheld Unit (Receiver) or Base Unit (Transmitter) to
direct heat or hot surfaces.
4. Not for use in microwave ovens.
5. Do not expose Base Unit (Transmitter) or meat probe plug connector to
water.
6. Do not use Handheld Unit (Receiver) or Base Unit (Transmitter) in the
rain.
7. Base Unit (Transmitter) registers temperatures as low as 14
CAUTION!
1. Locate the battery compartment on bottom of unit.
2. Carefully, remove battery cover.
3. Load 2AAA batteries (not included).
5. Replace battery cover.
BASE UNIT
BATTERY REPLACEMENT
1. Locate the battery compartment under belt clip
on the backside of the unit.
2. Slide belt clip off to access battery compartment.
3. Carefully, remove battery cover.
4. Load 2AAA batteries (not included).
5. Replace battery cover and belt clip.
HANDHELD UNIT
BATTERY REPLACEMENT
FCC NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation. Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.