Installation Guide

Step 5: INSTALL BOTTOM HINGES
& CROWN MOLDING
Step 8: ATTACH STRIKE PLATE
NOTE: Make sure screws on pivot
hinge are facing INTO the cabinet.
Wipe area where stripe plate will be attached, place strike plate
onto face of magnet, peel paper from foam tape and close door,
open door, press on strike plate to ensure good adhesion.
Push Latch
Strike Plate
Peel tape
backing
SWING DOOR PARTS LIST Mirror (1)
Adjustable
Shelves (2)
Shelf Support
(8)
Push Latch
(1)
Intended Strike
Plate location
Strike Plate
(TAPE SIDE OUT)
Strike Plate
(1)
Push Latch Screw
(2)
Hinge Bushing
(2)
Step 7: ATTACH DOORS
Use to
adjust
door
gap
Place hinge bushing into pivot hinge. Insert pivot hinge into top rail.
Slide bottom of mirror door into bottom pivot hinge. Tighten screw.
NOTE:
Doors require
adjustment or
glass could
break.
Door gap should
be consistent.
1.
2.
Push Latch
Hinge Bushing
Pivot Hinge
Pivot Hinge & Plate
(2) (2)
Pivot Hinge
(DO NOT OVER TIGHTEN)
Pivot Hinge
Hinge
Screw
Hinge
Plate
Mirror
Step 6: ATTACH TOP OF HINGE SET
Back of
Mirror
Hinge Plates:
Attach to mirror FIRST,
approximately 1/8" from inside edge.