SDS
Protective Equipment: Firefighters should wear a pressure demand self-contained breathing apparatus and
protective clothing.
6. Accidental Release Measures:
Person-Related Safety Precautions: Avoid contact with skin and eyes.
Measures for Environmental Protection:
Cover and contain spill with absorbent material. Collect for proper
disposal according to local, state, and federal regulations.
Small Spills: Absorb with earth, sand or other non-combustible material and transfer to containers for later
disposal. Wipe up with absorbent
material (e g. cloth, fleece) clean surface thoroughly to remove residual
contamination.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible.
Use a non
-combustible material like vermiculite, sand or earth to soak up the product and place into a
container for later disposal. Following
product recovery, flush area with water.
7. Handling and Storage:
Information for Safe Handling: Avoid contact with skin or inhalation.
Storage Requirements: Store in dry, well ventilated area. Avoid contact with moisture. Keep containers
tightly closed. Store between 60°F
-100°F. Material may settle.
Regulatory Requirements: Store according to all local, state, and federal regulations.
8. Exposure Controls and Personal Protection:
Other Exposure Limits
ACGIH Exposure Limits
OSHA Exposure Limits
Chemical Name / CAS No.
Siloxanes and silicones,
dimethyl, hydroxy-terminated
70131-67-8
Not Established
Not Established
Not Established
Quartz
14808-60-7
0.025 mg/m3 TWA
(respirable fraction)
Not Established
NIOSH: 0.05 mg/m3 TWA
(respirable dust)
Titanium dioxide
13463-67-7
10 mg/m3 TWA
15 mg/m3 TWA (total dust)
Not Established
2-Butanone,
O,O',O''-(methylsilylidyne)trioxime
22984-54-9
Not Established
Not Established
Not Established
Octamethylcyclotetrasiloxane
556-67-2
Not Established
Not Established
Not Established
Engineering Controls: No special measures required.
General Protective and Hygienic Measures: Usual precautionary measures should be adhered
to
SDS for: SeamlesSeal Ultra HS
Page 3 of 6
Printed: 11/21/2018 at 10:31:36AM