SDS

SDS MASTERFLEX ULTIMATE ARMOUR 200+ Page 3 of 6
from sources of heat, ignition and direct sunlight. Do not freeze
Keep closures tight and container upright to prevent leakage. Never use pressure to empty. Drum must not be
washed out or used for other purposes.
8: Exposure Control and Personal Protection
Chemical Name / CAS No.
OSHA Exposure Limits
ACGIH Exposure Limits
Other Exposure
Water / 7732-18-5
Not Established
Not Established
Not Established
Acrylic polymer /178037-05-3
Not Established
Not Established
Not Established
Titanium Dioxide / 13463-67-7
TWA:15 mg/m3 8 hours.
Form:Total dust
TWA: 10mg/m3 8 hours
Not Established
Limestone / 1317-65-3
15 mg/m3 TWA (total
dust); 5 mg/m3 TWA
(respirable fraction)
Not Established
NIOSH: 10 mg/m3
TWA (total dust); 5
mg/m3 TWA
(respirable dust)
Exposure Controls
Use adequate ventilation and/or engineering controls in high temperature processing to prevent exposure to
vapors.
Ensure adequate ventilation, especially in confined areas. Keep exposures below recommended exposure limits.
Personal protection equipment
Protection of hands:
Wear gloves of adequate length to offer appropriate skin protection from splashes. Nitrile, Butyl and PVC gloves
have been found to offer adequate protection for incidental contact.
Eye protection:
Wear approved eye protection (properly fitted dust- or splash-proof chemical safety glasses.
Respiratory protection:
Not required under typical use.
Skin and body protection:
Not required under normal use.
Skin should be washed after contact.
Remove and wash contaminated clothing before re – use.
Hygiene measures
Wash hands before breaks and immediately after handling the product.
When using do not eat, drink or smoke.
Protective measures:
Ensure that eyes flushing systems and safety shower are located close to the working place
Environmental exposure controls