SDS

SDS MASTERFLEX ULTIMATE ARMOUR 200+ Page 2 of 6
position and keep warm.
Eye Contact: Immediately rinse thoroughly with plenty of water for at least 15 minutes, remove contact
lenses if present and easy to do. Continue to flush with water, forcibly holding eyelids apart to ensure
complete irrigation of all of the eye and lid tissues. Flushing the eyes with water within several seconds is
essential to achieve maximum effectiveness. Seek immediate medical attention.
Skin Contact: Immediately flush with plenty of water for at least 15 minutes while removing
contaminated clothing and shoes. Wash off with soap and plenty of water. Consult a physician. Seek
Immediate medical attention.
Ingestion: Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Rinse
mouth thoroughly with water. If vomiting occurs spontaneously, keep airway clear. Keep head low so that
stomach content doesn't get into the lungs. Seek immediate medical attention.
Notes to Physician: Show this safety data sheet to the doctor in attendance. Probable mucosal damage may
contraindicate the use of gastric lavage
5: Fire Fighting Measures
Flash Point: None
LEL: NA UEL: NA
This is a water-based product and presents no particular fire or explosion hazard. Dry polymer film will burn.
Product contains low levels of organic volatiles which may be emitted at elevated temperatures.
Treat for surrounding material
Non-explosive in presence of shocks
Extinguishing Media: Use extinguishing measures that are appropriate to local circumstances and the
surrounding environment.
Fire Fighting: Closed containers may rupture if exposed to fire or extreme heat.
Fire Equipment: As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH
(approved or equivalent) and full protective gear.
Hazardous combustion products: may emit toxic fumes under fire conditions
6: Accidental Release Measures
Spill/Leak Procedures: Eliminate all sources of ignition, evacuate all unnecessary personnel
Small Spills: Soak up with inert absorbent material. Sweep up and shovel into suitable containers for disposal
Large Spills: Dike and contain spill. Place in a suitable non-leaking container and tightly seal for disposal.
Comply with all applicable health and environmental regulation. Prevent further leakage or spillage if safe to do
so.
Methods and material for containment and cleaning up:
Dispose contaminated material as waste according to item 13. Ensure adequate ventilation.
Environmental precautions: Do not allow to enter sewers/ surface or ground water.
7: Handling and Storage
Precautions for safe handling: Ensure good ventilation/exhaustion at the workplace. Wear appropriate PPE
(See section 8).
Information about protection against explosions and fires: No special measures required.
Requirements to be met by storerooms and receptacles: No special requirements.
Information about storage in one common storage facility: Not required.
Further information about storage conditions: Store between 5 and 35ºC in a dry, well ventilated place away