Use and Care Manual

Table Of Contents

NEVER LEAVE A FAN UNATTENDED WHILE OPERATING

OR WHILE CONNECTED TO A POWER SOURCE

Wall Mount Installation

Tools Needed:

Phillips screwdriver

Adjustable wrench (included in accessory bag)

1. Secure the wall mount to the desired location

with appropriate hardware (not provided).

2. Attach the bend pipe to the wall mount with

the provided bolts. Tighten the bolts.

3. Loosen the Phillips head set screw on the

lower supporter. Attach the motor to the bend

pipe by using the M12x40 screw, nut, and

washer to connect the lower supporter to the

upper supporter. Tighten the M12x40 screw

and the Phillips head set screw. Ensure the

screws are tight.

4. Remove the four (4) M6x10 Phillips head

ange screws from the motor.

5. Attach the rear guard to the motor with the

four (4) M6x10 Phillips head ange screws.

6. Attach the blade to the motor shaft by using

the allen wrench (in accessory bag). Make

sure the hex set screw is facing toward the

motor (hub down) when attaching.

7. Attach the front guard to the rear guard, using

the snap joint to tighten.

Operating Instructions

1. Conrm that the speed control knob is set to “O” off. Plug the cord into a standard 120 V A/C outlet.

2. Adjust to the desired speed setting.

The installer MUST be certain that

the support bracket is mounted to a

minimum of a 2x4" stud, and that it is able to support

50 pounds continuously.

WARNING

NOTE: The bolts and screws

are mix of metric and standard.

Exploded View

Front GuardBladesSet ScrewRear GuardMotor

Wall Mount

Upper Support

M12 Nut Lower Support

M12x40 Screw

M6x10 Flange Screw