Technical data

Manual – MOVI-PLC® advanced DH.41B Controller
7
2
MOVI-PLC® advanced DH.41B control card
Introduction
Control classes •MOVI-PLC
®
basic DHP11B enables the coordination of single axis movements and
the integration of external inputs / outputs and Drive Operator Panels (DOP). This
means MOVI-PLC
®
basic DHP11B is suitable as a module controller or a stand-
alone controller for machines of medium complexity.
•MOVI-PLC
®
advanced DH.41B is characterized by a greater variety of interfaces and
higher performance, which allows complex calculations and, for example, interpolat-
ed movements. MOVI-PLC
®
advanced is suitable for automating machines and
cells. The integrated Ethernet interface means that MOVI-PLC
®
advanced can be
connected directly to the control level.
2.2 MOVI-PLC
®
advanced DH.41B control card
Features The MOVI-PLC
®
advanced DH.41B control card is available in two mounting versions:
•As the control card MOVI-PLC
®
advanced DH.41B as an option for the
MOVIDRIVE
®
B and MOVITRAC
®
B inverters and the MOVIAXIS
®
servo drive
• As the compact controller MOVI-PLC
®
advanced DH.41B for installation on a DIN
rail. The compact controller version is designed to control inverters (→ Sec. 8 "Tech-
nical Data").
Unit versions The MOVI-PLC
®
advanced DH.41B control card is available in 2 versions, differing in
the fieldbus interfaces installed:
Engineering Engineering of the MOVI-PLC
®
advanced DH.41B control card includes the following
activities:
• Configuration
• Parameter setting
• Programming
These activities are carried out using the MOVITOOLS
®
MotionStudio engineering soft-
ware. The software has a number of useful features for startup and diagnostics of all
SEW-EURODRIVE units. MOVI-PLC
®
advanced DH.41B is connected to the engineer-
ing PC either via the Ethernet 2 or USD interface (in preparation).
Communication
interfaces
The MOVI-PLC
®
advanced DH.41B control card is equipped with a number of commu-
nication interfaces.
The two system bus interfaces CAN 1 and CAN 2 are used primarily for connection,
controlling several inverters and integrating decentralized I/O modules. SEW-
EURODRIVE recommends connecting no more than 256 inputs and 256 outputs to the
MOVI-PLC
®
advanced DH.41B control card.
Once you have set up a machine module in this way, you can operate it on a higher-level
controller via an integrated fieldbus interface.
Engineering is performed via the integrated Ethernet 2 or USB interface (in preparation).
An operator terminal (e.g. DOP11A) or a MOVIMOT
®
gearmotor with integrated
frequency inverter is connected to the RS485 interface.
MOVI-PLC
®
advanced DH.41B unit
version
Fieldbus interfaces
DHE41B Ethernet TCP/IP, UDP
DHF41B Ethernet TCP/IP, UDP, PROFIBUS DP-V1