Technical data

ManualsBrandsMaster ManualsDehumidifiersDH 41 H

Manual – MOVI-PLC® advanced DH.41B Controller

Configuration for a PROFIBUS DP master

Configuration and Startup

4.4 Configuration for a PROFIBUS DP master

You need a GSD file to configure a PROFIBUS DP master for controlling MOVI-PLC

advanced DHF41B.

GSD file for

PROFIBUS

DP/DP-V1

The GSD file SEW_6007.GSD corresponds to GSD revision 4. The device master data

files standardized by the PROFIBUS user group can be read by all PROFIBUS DP

masters.

General configu-

ration procedure

Proceed as follows to configure the MOVI-PLC

advanced DHF41B control card with

PROFIBUS DP interface:

1. Read the README_GSD6007.PDF file that you received with the GSD file to obtain

further up-to-date information on configuration.

2. Install (copy) the GSD file according to the requirements of your configuration

software (→ manuals of your configuration software or the section "Installing the

GSD file in STEP7", below). Once the file has been installed correctly, the device

appears next to the slave stations with the designation MOVI-PLC.

3. For configuration, add the MOVI-PLC

advanced DHF41B control card under the

name MOVI-PLC to the PROFIBUS structure and assign the PROFIBUS station ad-

dress.

4. Select the process data configuration required for your application (→ Section "DP

Configuration").

5. Enter the I/O or peripheral addresses for the configured data widths.

After configuration you can start PROFIBUS-DP. The Fault Profibus LED indicates the

status of the configuration (OFF → configuration OK).

Installing the

GSD file in STEP7

Proceed as follows to install the GSD file in STEP7:

1. Start the Simatic Manager.

2. Open an existing project and start the hardware configuration.

3. Close the project window in the HW Config. A new file version can only be installed

when the project window is closed.

4. Click on "Extras" / "Install new GSD..." and select the new GSD file with the name

SEW_6007.GSD.

The software installs the GSD file and the associated bitmap files in the STEP7 system.

The current version of the GSD file for controlling MOVI-PLC

advanced DHF41B is

available on the SEW website (http://www.sew-eurodrive.de) in the "Software" section.

Configuration tool DP master File name

All DP configuration tools to IEC 61158 for DP master stan-

dard

SEW_6007.GSD

Siemens S7 hardware configuration for all S7 DP masters

Do not change or expand entries in the GSD file! SEW assumes no liability for malfunc-

tions that occur in MOVI-PLC

or connected inverters if a GSD file has been modified!