Technical data

Manual – MOVI-PLC® advanced DH.41B Controller

Configuration and startup for drives

Configuration and Startup

4.2 Configuration and startup for drives

Configuration and startup for drives is described in the following library manuals:

4.3 Configuration and startup in the PLC Editor

For information on configuration and startup of the MOVI-PLC

advanced DH.41B

control card, refer to the "MOVI-PLC

Programming in the PLC Editor" system manual.

Drive Manual

MOVIDRIVE

MOVIAXIS

MPLCMotion_MDX and MPLCMotion_MX Libraries for MOVI-PLC

MOVITRAC

07 / B

MOVIMOT

MPLCMotion_MC07 and MPLCMotion_MM libraries for MOVI-PLC

If the MOVI-PLC

advanced DH.41B is to be operated in MOVIDRIVE

MDX61B, the

MOVIDRIVE

MDX61B inverter must have firmware status ".16" or higher.

This applies irrespective of whether the inverter is controlled by the installed

MOVI-PLC

advanced DH.41B control card or whether the inverter slot is only used to

install the MOVI-PLC

advanced DH.41B when other inverters are controlled at the

same time (e.g. MOVITRAC

B).