Technical data

Manual – MOVI-PLC® advanced DH.41B Controller

Configuration with the MOVITOOLS® MotionStudio PC software

Configuration and Startup

• Set the IP address of the PC interface:

– Under [Start] / [Settings] / [Network connections], choose the PC interface you

require and select the properties window of the PC interface from the context

menu.

– In the properties of the "Internet protocol (TCP/IP)" option, select the entry "Use

following IP address".

– Enter the net mask that is set in the MOVI-PLC

advanced DH.41B control card

(e.g. 255.255.255.0 when DIP switch S1 is in the top position).

– Set the IP address depending on the net mask. The IP addresses of the

MOVI-PLC

advanced DH.41B control card (Ethernet 2) and the PC interface

must differ with the exception of the areas defined by the net mask. In the area

defined by the net mask, the IP addresses have to be identical. Do not set the last

byte of the IP address to either 0 or 255.

Example:

In this example, the last 8 bits of the IP address of the MOVI-PLC

advanced

DH.41B control card and the PC interface must differ.

Address settings

for engineering

access via a

network

Proceed as follows to establish engineering access to the MOVI-PLC

advanced

DH.41B control card via an existing network:

• In the <Ethernet2...> section of the NetConfig.cfg configuration file in the "System"

folder of the SD memory card, enter the following data in accordance with the

specifications of your network administration:

– IP address

–Net mask

– Gateway address

• Change DIP switch S1 to the bottom position. Doing so makes sure that the new ad-

dress settings will take effect when the MOVI-PLC

advanced DH.41B control card

is restarted.

Net mask

Decimal Binary

255.255.255.0 11111111.11111111.11111111.00000000