Owner`s manual

52DO NOT DIVE.
SPA TROUBLE-SHOOTING GUIDE
SPA NOT HEATING
* If the spas heater has failed, the majority of the time it will trip the GFCI breaker. If the spa is not
heating and has not tripped the breaker, please follow these steps:
1.) Check the control panel for diagnostic messages. Refer to spa diagnostic message area in previ-
ous sections. Follow steps to alleviate message.
2.) Check water set temperature at control panel.
3.) Check for dirty filter. Clean if necessary.
4.) Check “heat mode” the spa is set in. Spa should be in standard/ready mode.
5.) Check the control panel for heater light indicator. If the light is on, the spa should be heating.
Wait a reasonable amount of time (approximately 1 hour) to see if the water temperature is
changing.
6.) Check to make sure that the pump is primed.
7.) Reset power to the spa at GFCI breaker.
8.) If spa is still not heating, contact your dealer for service.
GFCI IS TRIPPING
A ground fault circuit interrupter (GFCI) is required by the Electrical Code
for your protection. The tripping of the GFCI may be caused by a compo-
nent on the spa or by an electrical problem. Electrical problems include
but are not limited to, a faulty GFCI breaker, spa component, power fluc-
tuations, or improper wiring. It may be necessary to contact an electrician
if your dealer recommends doing so.