Owner`s manual

ManualsBrandsMaster Spas ManualsHome building and DecorTS 8.1

www.imperialspaparts.com

TOPSIDE CONTROL OPERATING INSTRUCTIONS

Warmer

1 Jets 2

Jet 1

Jet 2

Economy

Heat

Mode

Cooler

Light

Temperature Controls Buttons

When either of the buttons is pressed once, the display will show the temperature that has

been set. Each time either of the buttons is pressed again, the set temperature will in-

crease or decrease in increments of 1ºF depending on which button is pressed. After 3 seconds,

the display will automatically show the current spa water temperature.

Jets 1 Button

Jet 1

The control panel button designated

Jet 1

activates jet pump #1 when pressed. When the

Jet 1

button is manually pressed again, jets 1 will be deactivated. When the pump is in operation, the

LED

Jet 1

is illuminated.

Note:

After the

Jet 1

button on the topside control is used, the spa will automatically shut down within 20 minutes

of use. After the 20 minutes of use has expired, the jets may be restarted by pressing the

Jet 1

button again.

Jets 2 Button

Jet 2

(if equipped)

The topside control button designated

Jet 2

activates jet pump #2 when pressed.

Jet 2

Button, when

manually pressed, has a twenty minute time-out. If the

Jet 2

button is pressed again prior to comple-

tion of the 20 minute time-out, the pump 2 will be deactivated and the time-out will reset. When

pump 2 is in operation, the

Jet 2

LED is illuminated.