Owner`s manual

www.imperialspaparts.com
www.imperialspaparts.com
Trouble Shooting Guide
PROBLEM ITEMS TO CHECK
Motor does not start Disconnect switch open
Main fuse 30 amp blown
Thermal protect open on motor
Locked motor shaft (frozen)
Motor is bad may need to be replaced
Disconnected or Failing pump cord
Too low voltage
Noisy pump and motor Air lock within pump. (Bleed system by loosening unions on pump housing-
till only water comes out)
Worn motor bearing
Valve in suction line (if equipped) partially closed
Loose Motor mount (check mounting bolts tighten if needed)
Overheating problem Clogged filters (check & clean if needed)
Suction line partially Obstructed or plugged
Low water level
Partially clogged discharge line
Excessive jet pump(s) operation
Ambient (outside) temperature is too high
Mode will not change GFCI in supply circuit breaker tripped
Possible bad power supply to the circuit board
Abnormal water usage Leak in plumbing.
Excessive evaporation and/or splashing.
NOTE: THE SKILLS AND TOOLS NECESSARY FOR THE SAFE REPAIR OF THIS SPA
REQUIRE THE SERVICES OF AN AUTHORIZED SERVICE TECHNICIAN.
Product specifications are subject to change without notice.
Use the installation instructions supplied with this product.
21