Owner`s manual

www.imperialspaparts.com

Trouble Shooting Guide

PROBLEM ITEMS TO CHECK

Control System Problems See Error Messages

Spa Does Not Operate GFCI in supply circuit tripped

Insufficiant or no voltage in power supply circuit

High Temperature – “OHT” displayed on the topside

Fuse blown

Water Not Heating Heater not energized adjust thermostat setting to a higher setting

Low Temperature Spa not covered

Ambient temperature too low (below freezing)

Pressure/flow switch malfunction

Filter or filter line clogged

Spa in “Eco” mode

Pressure/flow switch wires possibly loose (“PS1”).

Water temperature sensor open (“TS”)

Heat - temp. sensor opened (“HTS”)

Control Circuit board malfunction

Primary pump cavitating

Circulation pump stopping

Circulation pump detected a Thermal overload & not running

Poor Water Flow Primary pump not primed

No Water Flow Closed discharge line (if equipped)

Closed suction valve (if equipped)

Air lock in primary pump or water line

Filter plugged (clean 1-2 times a month)

Water level too low

Impeller clogged or damaged

Suction or discharge line partially closed or clogged

Main 30 amp fuse blown out

Motor overheated protection tripped

Jets closed (check all jets)

NOTE:

THE SKILLS AND TOOLS NECESSARY FOR THE SAFE REPAIR OF THIS SPA REQUIRE THE

SERVICES & EXPERTISE OF AN AUTHORIZED SERVICE TECHNICIAN.

Product specifications are subject to change without notice.

Use the installation instructions supplied with this product.