Owner`s manual

Page 39 Bullfrog Spas Owner’s Manual
Solution: Touch any button on the Control Pad to
reset High Limit.
Cause: 4. Heating System is defective.
Solution: Contact your authorized Bullfrog Portable
Spa Dealer.
PROBLEM: Spa Light does not work.
Cause: 1. Light bulb has burned out.
Solution: See "Light Bulb Replacement" in this
Owner's Manual.
Cause: 2. Lighting System is defective.
Solution: Contact your authorized Bullfrog Portable
Spa Dealer.
PROBLEM: Spa pump will not turn on, creates
burning smell when running, or makes excessive
noise when running.
Cause: Pump motor is defective.
Solution: Contact your authorized Bullfrog Portable
Spa Dealer.
PROBLEM: Jets surge on and off.
Cause: Water level in spa is too low.
Solution: Adjust water level to any point between
the two water level indentation marks on the back
wall of the filter/skimmer cavity.
PROBLEM: Jets are weaker than normal or do
not work at all, but in both cases the pump is
running.
Cause: 1. Spa filter cartridge is dirty.
Solution: See "Cleaning Your Filter" in this Owner's
Manual.
Cause: 2. There is air trapped in the spa equipment
or its face piping.
Solution: Open the air-bleed valve on each pump
housing and allow air to bleed out of system. Be
sure to tighten each air-bleed valve as soon as water
starts to flow out.
Cause: 3. The Suction Fitting(s) are blocked.
Solution: Remove any item or debris that is blocking
each Suction Fitting.
Cause: 4. The JetZone Divider is not installed (This
only applies to spas that have two pumps).
Solution: Re-install in the appropriate JetPak
position. (Warning: Running your spa without a
JetZone Divider can cause serious damage to your
pump.)
Cause: 5. Slice Valve is closed.
Solution: Open Valve and secure with Valve Keeper.