Owner`s manual

Page 29 Bullfrog Spas Owner’s Manual
To maintain the above sanitizer level with CHLORINE
or BROMINE TABLETS, please refer to your
authorized Bullfrog Portable Spa Dealer for
assistance.
Super-Sanitation:
Once per week, and when the spa is not in use,
Super-Sanitize the spa water by adding one of the
following:
• Two teaspoons of GRANULAR CHLORINE per 200
gallons of spa water.
• Four teaspoons of GRANULAR BROMINE per 200
gallons of spa water.
• Five teaspoons of a NON-CHLORINE SHOCK per
200 gallons of spa water.
Note 1: With above-average use, Super-Sanitation
may be required more than once per week.
Note 2: With ozone, it may not be necessary to
shock on a weekly basis (see your dealer).
Stain & Scale Control: Use a STAIN & SCALE
INHIBITOR as per the instructions on the
manufacturer's label. Do not add this chemical until
3-4 days after Super-Sanitation.
Foam Control: As needed, use a FOAM REMOVER as
per the instructions on the manufacturer's label.
Cloudy Water Prevention & Control: Use a WATER
CLARIFIER as per the instructions on the
manufacturer's label. Do not add this chemical until
3-4 days after Super-Sanitation.
WATER CHEMISTRY TROUBLESHOOTING
Prior to each spa use, check the spa water. If the
water appears cloudy or off-color, has significant
surface foam or smells of chlorine/bromine, then
there is a problem with the water and it needs to be
treated or drained. Using the spa in these
conditions could result in a skin rash or other
irritation.
For assistance in handling spa water chemistry
problems, consult your authorized Bullfrog Portable
Spa Dealer or another service center capable of
performing a Computerized Water Analysis.